When is the right time to replace your Loftness parts? Well, this is the question that most people don’t get right. Some of the machine users end up doing early replacement when the parts could have been used for a little longer. In other cases, the replacement is done too late after the machine has already damaged.

If you are using your Loftness machine or any other mulcher brand for the first time, we have the best tips on when to make a replacement for the worn-out parts. Here are some of the best tips.

Reduced Performance

One of the ways that you can tell that your Loftness parts may need a replacement is reducing performance. Once the parts wear out, their effectiveness in cutting the foliage starts to reduce. This means that their cutting performance will start reducing. Therefore, the overall performance of the machine is reduced with the wearing out of the machine. If you have tried to do the maintenance and nothing is coming out, then a replacement of the parts would be necessary.

Low Productivity

The other sign that you might need to make Loftness parts replacement is the dwindling productivity of the machine. If you notice that the mulcher performance has been falling at a very fast rate and nothing that you have done, including maintenance, has been able to raise the production of the machine to the pick, then you need to consider replacing the parts. Note that the productivity of the machine is significantly determined by the quality of tools.

Frequent Repairs

Another sign that you might need to replace your Loftness parts is the frequent repairs of the machine parts. If you have good machine parts, the need for replacement will not arise so often. It happens ones in a while, and it should not affect your work. But if things are happening so often, then you need to consider making a replacement with new parts.

High Fuel Consumption

The other sign that will tell you that it’s time to replace your Loftness parts is the high fuel consumption. If you notice that the machine is consuming too much fuel for the same task, it was doing before, and even repairs and maintenance is improving it, get the parts replaced. Consuming too must fuel is a sign that parts efficiency is very low, and the machine is being forced to work harder.